Release Notes

Parameter Description Range Default
fer-low-wm
After a frame error rate exceeded condition
exists, the condition persists until the frame
error rate drops below this value. The
recommended value is 8%.
0-100 0%
ffr-high-wm
If the frame fragmentation rate (as a percentage
of total frames in an AP) exceeds this value, a
frame fragmentation rate exceeded condition
exists. The recommended value is 16%.
0-100 16%
ffr-low-wm
After a frame fragmentation rate exceeded
condition exists, the condition persists until the
frame fragmentation rate drops below this
value. The recommended value is 8%.
0-100 8%
flsr-high-wm
If the rate of low-speed frames (as a percentage
of total frames in an AP) exceeds this value, a
low-speed rate exceeded condition exists. This
could indicate a coverage hole. The
recommended value is 16%.
0-100 16%
flsr-low-wm
After a low-speed rate exceeded condition
exists, the condition persists until the
percentage of low-speed frames drops below
this value. The recommended value is 8%.
0-100 8%
fnur-high-wm
If the non-unicast rate (as a percentage of total
frames in an AP) exceeds this value, a non-
unicast rate exceeded condition exists. This
value depends upon the applications used on the
network.
0-100 0%
fnur-low-wm
After a non-unicast rate exceeded condition
exists, the condition persists until the non-
unicast rate drops below this value.
0-100 0%
frer-high-wm
If the frame receive error rate (as a percentage
of total frames in an AP) exceeds this value, a
frame receive error rate exceeded condition
exists. The recommended value is 16%.
0-100 16%
frer-low-wm
After a frame receive error rate exceeded
condition exists, the condition persists until the
frame receive error rate drops below this value.
The recommended value is 8%.
0-100 8%
frr-high-wm
If the frame retry rate (as a percentage of total
frames in an AP) exceeds this value, a frame
retry rate exceeded condition exists. The
recommended value is 16%.
0-100 16%
frr-low-wm
After a frame retry rate exceeded condition
exists, the condition persists until the frame
retry rate drops below this value. The
recommended value is 8%.
0-100 8%
no
Negates any configured parameter. — —
Dell Networking W-Series ArubaOS 6.4.x | Reference Guide rf event-thresholds-profile | 686