Release Notes

655 | rf arm-profile Dell Networking W-Series ArubaOS 6.4.x| Reference Guide
Parameter Description Range Default
If enabled, the controller compares
whether or not an AP has more clients
than its neighboring APs on other
channels. If an AP’s client load is at or
over a predetermined threshold as
compared to its immediate neighbors,
or if a neighboring Dell AP on another
channel does not have any clients, load
balancing will be enabled on that AP.
This feature is enabled by default
clone
Name of an existing ARM profile from
which parameter values are copied.
— —
cm-band-a-min-signal <cm-
band-a-min-signal>
Minimum signal level required for the tar-
geted A band radio in a Client Match
band steer move (-dBm).
— 75
cm-band-g-max-signal <cm-
band-g-max-signal>
Maximum signal level of the G band radio
that can trigger a Client Match band steer
move (-dBm)
— 45
cm-lb-client-thresh
<#-of-clients>
If an APradio has fewer clients than the
client match load balancing threshold
defined by this parameter, the AP will not
participate in load balancing.
0-100 clients 30
cm-lb-signal-delta
Client match will not move a client to a
new radio if the signal strength of the tar-
get AP is this dB value lower than the
radio to which the client is currently asso-
ciated. This parameter works differently
than the cm-lb-snr-thresh value, which
imposes a definite value on the target
AP's signal-to-noise radio. the cm-lb-sig-
nal-delta imposes a relative constraint
based upon the signal strength of the
radio to which the client is currently asso-
ciated.
0-20 dB 5 dB
cm-lb-snr-thresh <dB>
Clients must detect a SNR from an under-
utilized AP radio at or above this
threshold before the client match feature
considers load balancing a client to that
radio.
0-100 dB 25
cm-lb-thresh
<%-of-clients>
When the client match feature is enabled,
clients may be steered from a highly util-
ized channel on an AP to a channel with
fewer clients. If a channel on an APradio
has this percentage fewer clients than
another channel supported by the client,
the client match feature may move clients
from the busier channel to the channel
with fewer clients.
0-100 % 20
cm-max-steer-fails
<#-of-fails>
The controller keeps track of the number 0-100 failures 5