Release Notes

Usage Guidelines
Use the remote-node-profile command to create a Remote Node profile. You define configuration settings
for each Remote Node through a Remote Node profile on the Remote Node-master. The Remote Node-master
must be a master controller.
Related Commands
Command Description Mode
remote-node-localip (deprecated)
Configures security for all
Remote Node and Remote
Controller control traffic
Enable and
Config mode
remote-node-masterip (deprecated)
Configures security for the
Remote Node master IP
address.
Enable and
Config mode
local-userdb-remote-node (deprecated)
This command adds a Remote
Node to the Remote Node
whitelist. You can also delete
the whitelist entry using this
command.
Enable and
Config mode
show remote-node (deprecated)
Shows Remote Node
configuration, dhcp instance,
license usage and running
configuration information.
Enable and
Config mode
show remote-node-dhcp-pool (deprecated)
Shows Remote Node dhcp pool
configuration information.
Enable and
Config mode
show remote-node-profile (deprecated)
Shows Remote Node profile
status information.
Enable and
Config mode
show local-userdb-remote-node (deprecated)
The output of this command
lists the MAC address and
assigned remote-node-profile
for each Remote Controller
associated with that Remote
Controller master.
Enable and
Config mode
Command History
Modification
ArubaOS 6.0 Command introduced.
ArubaOS 6.1 The controller-ip loopback parameter was deprecated.
The following parameters were added:
l ipv6
l mgmt-server
l mobility-manager
l snmp-server
l syscontact
l syslocation
ArubaOS 6.2 Command deprecated.
Dell Networking W-Series ArubaOS 6.4.x | Reference Guide remote-node-profile (deprecated) | 644