Release Notes

P-
a-
r-
a-
m-
e-
t-
e-
r
Description
R-
a-
n-
g-
e
m
e
s
h-
s
a
e
Enable or disable Simultaneous Authentication of Equals (SAE) on a mesh network. This option offers
enhanced security over the default wpa2-psk-aes mesh security setting, and provides secure, attack-
resistant authentication using a pre-shared key. SAE supports simultaneous initiation of a key exchange,
allowing either party to initiate an exchange or both parties to initiate a key exchange simultaneously
To use the SAE feature, you must enable this parameter on all mesh nodes (points and portals) in the
network, to prevent mesh link connectivity issues.
NOTE: This is a Beta feature only. This parameter should be kept “disabled” for this release.
—
n
et
m
a
sk
Netmask for the IP address. —
n
o
Negates any configured parameter. —
p
a
p-
p
a
ss
w
d
Password Authentication Protocol (PAP) password for the AP.
You can use special characters in the PAP password. Following are the restrictions:
l You cannot use double-byte characters
l You cannot use a tilde (~)
l You cannot use a tick (‘)
l If you use quotes (single or double), you must use the backslash (\) before and after the password
—
p
a
p-
u
s
er
PAP username for the AP.
—
p-
kc-
s-
1-
2-
passphrase
Passphrase in PKCS12 format. —
Dell Networking W-Series ArubaOS 6.4.x | Reference Guide provision-ap | 620