Release Notes

interface vlan
interface vlan <vlan>
bandwidth-contract <name>
bcmc-optimization
description <string>
ip {address <ipaddr>|dhcp-client client-id<cid>|internal|pppoe}|helper-address
<address>|igmp [proxy][snooping]|local-proxy-arp|nat[inside]|{ospf
{area|authentictaion|cost|dead-interval|hello-interval|message-digest-
key|priority|retransmit-interval|transmit-delay}| pppoe-max-segment-size <mss>| pppoe-
password <password>|pppoe-service-name <service-name>|pppoe-username <username>|routing}
ipv6 {address <ipv6-address> link-local | [<ipv6-prefix>/<prefix-length> | eui-64]}| {dhcp
server <pool name>}| {mld snooping | proxy {fastethernet | gigabitethernet | port-channel}
<slot>/<port>} | nd {ra [dns | enable | hop-limit | interval | life-time | managed-config-
flag | mtu | other-config-flag | preference | prefix] | reachable-time <value> |
retransmit-time <value>}}
mtu <number>
multimode-auth {lease-time}
no ...
operstate {up}
option-82 {ap-name|mac}
shutdown
suppress-arp
Description
This command configures a VLAN interface.
Syntax
Parameter Description Range Default
vlan
VLAN ID number. 1-4094 —
bandwidth-contract
<name>
Name of the bandwidth
contract to be applied to
this VLAN interface. When
applied to a VLAN, the
contract limits both
broadcast and multicast
traffic. Use the aaa
bandwidth-contract
command to configure a
bandwidth contract.
— —
bcmc-optimization
Enables broadcast and
multicast traffic
optimization to prevent
flooding of broadcast and
multicast traffic on VLANs.
If this feature is enabled
on uplink ports, any
controller-generated
Layer-2 packets will be
dropped.
— disabled
description
String that describes this
interface.
— 802.1Q
VLAN
Dell Networking W-Series ArubaOS 6.4.x | Reference Guide interface vlan | 424