Release Notes

interface tunnel
interface tunnel <number>
description <string>
inter-tunnel-flooding
ip address <ipaddr> <netmask>
ipv6 address X:X:X:X::X
mtu <mtu>
no ...
shutdown
trusted
tunnel destination {<A.B.C.D>|ipv6 <X:X:X:X::X>}|keepalive <interval>|<retries>|mode gre
{<num>|ip|ipv6}|source {<A.B.C.D>|controller-ip|ipv6 {X:X:X:X::X|controller-
ip|loopback|vlan <vlan id>}|loopback|vlan <vlan id>}|vlan <vlan id>}
Description
This command configures a tunnel interface.
Syntax
Parameter Description Range Default
tunnel
Identification number for the tunnel. 1-
2147483647
—
description
String that describes this interface. — Tunnel
Interface
inter-tunnel-flooding
Enables inter-tunnel flooding. — enabled
ip
IP address of the tunnel. This represents the
entrance to the tunnel, enter the following
values:
l address—specify interface IPaddress
n <ipaddr>—specify an IPv4 address
n internal—IP address allocated from
the Remote-Node pool
n <ipmask>—IPaddress allocated
form the Remote-Node pool
l ospf—OSPFinterface command
— —
ipv6
IPv6 address of the tunnel.
Note:This address can be configured only for a
L3 GRETunnel Interface.
- -
mtu
MTU size for the interface.
1024 - 9216
enabled
IPv4 - 1100
IPv6 - 1500
no
Negates any configured parameter. — —
shutdown
Causes a hard shutdown of the interface. — —
Dell Networking W-Series ArubaOS 6.4.x | Reference Guide interface tunnel | 420