Release Notes

219 | ap-name Dell Networking W-Series ArubaOS 6.4.x| Reference Guide
Parameter Description Default
dot11g-radio-
profile
Configures 802.11g radio settings for the AP group;
contains the ARM profile. See rf dot11a-radio-profile
on page 664.
“default”
dot11g-traffic-
mgmt-profile
Configures bandwidth allocation. See wlan traffic-
management-profile on page 2079.
—
enet0-profile
Configures the duplex and speed of the Ethernet 0
interface on the AP. See ap enet-link-profile on page
148.
“default”
enet1-profile
Configures the duplex and speed of the Ethernet 1
interface on the AP. See ap enet-link-profile on page
148.
“default”
event-thresholds-profile
Configures Received Signal Strength Indication (RSSI)
metrics. See rf event-thresholds-profile on page 685.
“default”
exclude-mesh-cluster-profile-ap
Excludes the specified mesh cluster profile from this
AP.
The Secure Enterprise Mesh license must be installed.
—
exclude-virtual-ap
Excludes the specified virtual AP profiles from this AP.
ids-profile
Configures Dell’s Intrusion Detection System (IDS).
See ids profile on page 381.
“default”
mesh-cluster-profile
Configures the mesh cluster profile for the AP (mesh
node). There is a “default” mesh cluster profile;
however, it is not applied until you provision the mesh
node. See ap mesh-cluster-profile on page 161.
The Secure Enterprise Mesh license must be installed.
“default”
priority
Configures the priority of the mesh cluster profile. If
more than two mesh cluster profiles are configured,
mesh points use this number to identify primary and
backup profile(s).
The supported range of values is 1-16. The lower the
number, the higher the priority.
1
mesh-radio-profile
Configures the 802.11g and 802.11a radio settings for
the AP (mesh node). See ap mesh-ht-ssid-profile on
page 163.
The Secure Enterprise Mesh license must be installed.
“default”
no
Negates any configured parameter. —
regulatory-domain-profile
Configures the country code and valid channels. See
ap regulatory-domain-profile on page 182.
“default”
rf-optimization
-profile
Configures load balancing and coverage hole and
interference detection. See rf optimization-profile on
page 690.
“default”
snmp-profile
Configures SNMP-related parameters. See ap snmp-
profile (deprecated) on page 187.
“default”
virtual-ap
One or more profiles, each of which configures a
specified WLAN. See wlan virtual-ap on page 2085.
“default”