Release Notes

213 | ap-group Dell Networking W-Series ArubaOS 6.4.x| Reference Guide
Parameter Description Range Default
mesh-radio-profile
Configures the 802.11g and 802.11a radio
settings for mesh nodes that are members
of the AP group. See ap mesh-ht-ssid-
profile on page 163.
Commands to configure mesh for outdoor
APs require the Outdoor Mesh license.
— “default”
no
Negates any configured parameter. — —
regulatory-domain-profile
Configures the country code and valid
channels. See ap regulatory-domain-profile
on page 182.
— “default”
rf-optimization-profile
Configure coverage hole and interference
detection. See rf optimization-profile on
page 690.
— “default”
virtual-ap
One or more profiles, each of which
configures a specified WLAN. See wlan
virtual-ap on page 2085.
— “default”
voip-cac-profile
Configures voice over IP (VoIP) call
admission control (CAC) options. See wlan
voip-cac-profile on page 2096.
This parameter requires the PEFNG
license.
— “default”
Usage Guidelines
AP groups are at the top of the configuration hierarchy. An AP group collects virtual AP definitions and
configuration profiles, which are applied to APs in the group.
Example
The following command configures a virtual AP profile to the “default” AP group:
(host)(config) #ap-group default
virtual-ap corpnet
Related Commands
View AP group settings using the command show ap-group.
Command History:
Release Modification
ArubaOS 3.0 Command introduced
ArubaOS 3.2 Support for the mesh parameters was introduced
ArubaOS 3.4.1 The voip-cac-profile parameter required the PEF license.
ArubaOS 5.0 The voip-cac-profile parameter requires the PEFV license.
ArubaOS 6.0 The enet-port-profile parameters parameters were introduced.