Release Notes

2073 | wlan ssid-profile Dell Networking W-Series ArubaOS 6.4.x| Reference Guide
Description Range Default
g-basic-rates
List of supported 802.11b/g rates that
are advertised in beacon frames and
probe responses.
1, 2, 5, 6, 9, 11,
12, 18, 24, 36,
48, 54 Mbps
1, 2 Mbps
g-beacon-rate
Sets the beacon rate for 802.11g (use
for Distributed Antenna System (DAS)
only). Using this parameter in normal
operation may cause connectivity
problems.
default, 1,2,5,
6 9, 11, 12, 18,
24, 36, 48, 54
Mbps
minimum
valid rate
g-tx-rates
Set of 802.11b/g rates at which the AP is
allowed to send data. The actual
transmit rate depends on what the client
is able to handle, based on information
sent at the time of association and on
the current error/loss rate of the client.
1, 2, 5, 6, 9, 11,
12, 18, 24, 36,
48, 54 Mbps
1, 2, 5, 6, 9,
11, 12, 18,
24, 36, 48, 54
Mbps
hide-ssid
Enables or disables hiding of the SSID
name in beacon frames. Note that
hiding the SSID does very little to
increase security.
— disabled
ht-ssid-profile
Name of high-throughput SSID profile to
use for configuring high-throughput
support. See wlan ht-ssid-profile on
page 2062.
— “default”
local-probe-req-thresh
APs will not respond to client probe
requests if the SNR value in the probe
request is less than the specified
threshold value.
0-100 0
max-clients
Maximum number of wireless clients for
the AP.
0-256 64
max-retries
Maximum number of retries allowed for
the AP to send a frame.
0-15 4
max-tx-fail
The AP assumes the client has left and
should be deauthorized when the AP
detects this number of consecutive
frames were not delivered because the
max-retries threshold was exceeded.
0 -
2,147,483,647
0
mcast-rate-opt
Enables or disables scanning of all
active stations currently associated to
an AP to select the lowest transmission
rate for broadcast and multicast frames.
This option only applies to broadcast
and multicast data frames; 802.11
management frames are transmitted at
the lowest configured rate.
NOTE: Do not enable this parameter
unless instructed to do so by your Dell
technical support representative.
— disabled
mfp-capable
When enabled, the SSID supports man-
agement frame protection (MFP) capable
clients and traditional clients.
— disabled