Release Notes

Parameter Description Range Default
This setting is useful when deploying,
maintaining, or upgrading the network.
If enabled, APs stop flooding
unnecessary traps and syslog
messages to network management
systems or network operations centers
when deploying, maintaining, or
upgrading the network. The controller
still generates debug syslog messages
if debug logging is enabled.
max-request-re
tries
Maximum number of times to retry AP-
generated requests, including
keepalive messages. After the
maximum number of retries, the AP
either tries the IP address specified by
the bkup-lms-ip (if configured) or
reboots.
1-65535 10
mtu
MTU, in bytes, on the wired link for the
AP.
1024-
1578
—
native-vlan-id
Native VLAN for bridge mode virtual
APs (frames on the native VLAN are
not tagged with 802.1q tags).
— 1
no
Negates any configured parameter. — —
number-ipsec-retries
The number of times the AP will
attempt to recreate an IPsec tunnel
with the master controller before the
AP will reboot. A value of 0 disables the
reboot.
1-1000 85
rap-bw-total
This is the total reserved uplink
bandwidth (in Kilobits per second).
— —
rap-bw-resv-1
Session ACLs with uplink bandwidth
reservation in kilobits per second. You
can specify up to three session ACLs to
reserve uplink bandwidth. The sum of
the three uplink bandwidths should not
exceed the rap-bw-total value.
— —
rap-bw-resv-2
— —
rap-bw-resv-3
— —
rap-dhcp-
default-router
IP address for the default DHCP router.
—
192.168.11.1
rap-dhcp-dns-
server
IP address of the DNS server.
—
192.168.11.1
rap-dhcp-lease
The amount of days that the assigned
IP address is valid for the client.
Specify the lease in <days>.
0 indicates the IP address is always
valid; the lease does not expire.
0-30 0
rap-dhcp-pool-
end
Configures a DHCP pool for remote
APs. This is the last IP address of the
DHCP pool.
—
192.168.11.254
Dell Networking W-Series ArubaOS 6.4.x | Reference Guide ap system-profile | 196