Release Notes

1177 | show ap system-profile Dell Networking W-Series ArubaOS 6.4.x| Reference Guide
Column Description
LMS Preemption
When this parameter is enabled, the local management switch
automatically reverts to the primary LMS IP address when it
becomes available.
LMS Hold-down Period
Time, in seconds, that the primary LMS must be available before
an AP returns to that LMS after failover.rap-dhcp-server-vlan
VLAN ID of the remote AP DHCP server used if the controller is
unavailable. This VLAN enables the DHCP server on the AP (also
known as the remote AP DHCP server VLAN). If you enter the
native VLAN ID, the DHCP server is unavailable.
Remote-AP DHCP Server VLAN
VLAN ID of the remote AP DHCP server used if the controller is
unavailable. This VLAN enables the DHCP server on the AP (also
known as the remote AP DHCP server VLAN).
Remote-AP DHCP Server ID
IP address used as the DHCP server identifier.
Remote-AP DNS Server
IP address of the DNS server.
Remote-AP DHCP Default Router
IP address for the default DHCP router.
Remote-AP DHCP Pool Start
This parameter defines the starting IP address in the DHCP pool
for remote APs.
Remote-AP DHCP PoolEn
d
This parameter defines the last IP address in the DHCP pool for
remote APs.
Remote-AP DHCP PoolNe
tmask
Configures a DHCP pool for remote APs. This is the netmask used
for the DHCP pool.
Remote-AP uplink total bandwidth
This is the total reserved uplink bandwidth (in Kilobits per second).
Remote-AP bw reservation 1
Remote-AP bw reservation 2
Remote-AP bw reservation 3
Session ACLs with uplink bandwidth reservation in kilobits per
second. You can specify up to three session ACLs to reserve
uplink bandwidth. The sum of the three uplink bandwidths should
not exceed the rap-bw-total value.
Remote-AP Local Network Access
Shows if Remote-AP Local Network Access is enabled or disabled.
By enabling this option, the clients that are connected to a RAP
can communicate.
Note: By default, the Remote-AP Local Network Access will be
disabled.
Bootstrap threshold
Number of consecutive missed heartbeats on a GRE tunnel
(heartbeats are sent once per second on each tunnel) before an
AP rebootstraps. On the controller, the GRE tunnel timeout is 1.5 x
bootstrap-threshold; the tunnel is torn down after this number of
seconds of inactivity on the tunnel.
Double Encrypt
This parameter applies only to remote APs. Double encryption is
used for traffic to and from a wireless client that is connected to a
tunneled SSID. When enabled, all traffic is re-encrypted in the
IPsec tunnel. When disabled, the wireless frame is only
encapsulated inside the IPsec tunnel.