Release Notes

RTLS Server configuration N/A
Telnet Disabled
The output of this command includes the following information:
Column Description
RF Band
For dual-band radios, this parameter displays the RF band in
which the AP should operate:
l g = 2.4 GHz
l a = 5 GHz
RF Band for AM mode scanning
Scanning band for multiple RF radios.
l g = 2.4 GHz
l a = 5 GHz
l all = Radio scans both bands. This is the default setting.
Native VLAN ID
Native VLAN for bridge mode virtual APs (frames on the native
VLAN are not tagged with 802.1q tags).
Tunnel Heartbeat Interval
Interval between heartbeat messages between a remote or campus
AP and its associated controller. An increase in the heartbeat inter-
val increases the time it will take for an AP to detect the loss in con-
nectivity to the controller, but can reduce internet bandwidth
consumed by a remote AP.
Session ACL
This parameter shows the access control list (ACL) applied on the
uplink of a remote AP.
Corporate DNS Domain
DNS name used by the corporate network.
SNMP sysContact
SNMP system contact information.
SAP MTU
Maximum Transmission Unit (MTU) size, in bytes. This value
describes the greatest amount of data that can be transferred in
one physical frame.
LMS IP
The IP address of the local management switch (LMS)—the Dell
controller which is responsible for terminating user traffic from
the APs, and processing and forwarding the traffic to the wired
network.
NOTE: If the LMS-IP is blank, the access point will remain on the
controller that it finds using methods like DNS or DHCP. If an IP
address is configured for the LMS IP parameter, the AP will be
immediately redirected to the controller at that address.
Backup LMS IP
For multi-controller networks, this parameter displays the IP
address of a backup to the IP address specified with the lms-ip
parameter.
LMS IPv6
In multi-controller ipv6 networks, this parameter specifies the
IPv6 address of the local management switch (LMS)—the Dell
controller—which is responsible for terminating user traffic from
the APs, and processing and forwarding the traffic to the wired
network. This can be the IP address of the local or master
controller.
Backup LMS IPv6
In multi-controller ipv6 networks, this parameter specifies the
IPv6 address of a backup to the IPv6 address specified with the
LMS IPv6 setting.
Dell Networking W-Series ArubaOS 6.4.x | Reference Guide show ap system-profile | 1176