Reference Guide

Dell PowerConnect ArubaOS 5.0 Command Line Interface | Reference Guide uplink | 1237
uplink
crypto-local
uplink {cellular priority <prior>}|disable|enable|{wired priority <prior>}|{wired
vlan <id>}
Description
Manage and configure the uplink network connection on the W-600 controllers.
Syntax
Usage Guidelines
The W-600 controllers supports multiple 3G cellular uplinks in addition to its standard wired ports, providing
redundancy in the event of a connection failure. If an W-600’s wired link cannot access the internet, the
controller can fail over to a secondary cellular link and continue routing traffic.
Command History
This command was introduced in ArubaOS 3.4.
Command Information
Parameter Description Range
cellular priority <prior> Set the priority of the cellular uplink. By default, the cellular uplink is a
lower priority than the wired uplink; making the wired link the primary
link and the cellular link the secondary or backup link.
Configuring the cellular link with a higher priority than your wired link
priority will set your cellular link as the primary controller link.
1-255
enable Enable the uplink manager.
—
disable Disable the uplink manager. —
wired priority <prior> Set the priority of the wired uplink. Each uplink type has an associated
priority; wired ports having the highest priority by default.
1-255
wired vlan <id> Define the VLAN identification (ID) of the uplink VLAN. 1-4094
Platforms Licensing Command Mode
W-600 controllers Base operating system Config mode on master and local controllers