Reference Guide

480 | rf event-thresholds-profile Dell PowerConnect W-Series ArubaOS 6.1 CLI | Reference Guide
Usage Guidelines
The event threshold profile configures Received Signal Strength Indication (RSSI) metrics. When certain RF
parameters are exceeded, these events can signal excessive load on the network, excessive interference, or faulty
equipment. This profile and many of the detection parameters are disabled (value is 0) by default.
Example
The following command configures an event threshold profile:
(host) (config) #rf event-thresholds-profile et1
detect-frame-rate-anomalies
Command History
This command was introduced in ArubaOS 3.0
ffr-low-wm After a frame fragmentation rate exceeded condition
exists, the condition persists until the frame fragmentation
rate drops below this value. The recommended value is
8%.
0-100 8%
flsr-high-wm If the rate of low-speed frames (as a percentage of total
frames in an AP) exceeds this value, a low-speed rate
exceeded condition exists. This could indicate a coverage
hole. The recommended value is 16%.
0-100 16%
flsr-low-wm After a low-speed rate exceeded condition exists, the
condition persists until the percentage of low-speed
frames drops below this value. The recommended value is
8%.
0-100 8%
fnur-high-wm If the non-unicast rate (as a percentage of total frames in
an AP) exceeds this value, a non-unicast rate exceeded
condition exists. This value depends upon the applications
used on the network.
0-100 0%
fnur-low-wm After a non-unicast rate exceeded condition exists, the
condition persists until the non-unicast rate drops below
this value.
0-100 0%
frer-high-wm If the frame receive error rate (as a percentage of total
frames in an AP) exceeds this value, a frame receive error
rate exceeded condition exists. The recommended value
is 16%.
0-100 16%
frer-low-wm After a frame receive error rate exceeded condition
exists, the condition persists until the frame receive error
rate drops below this value. The recommended value is
8%.
0-100 8%
frr-high-wm If the frame retry rate (as a percentage of total frames in
an AP) exceeds this value, a frame retry rate exceeded
condition exists. The recommended value is 16%.
0-100 16%
frr-low-wm After a frame retry rate exceeded condition exists, the
condition persists until the frame retry rate drops below
this value. The recommended value is 8%.
0-100 8%
no Negates any configured parameter. — —
Parameter Description Range Default