Reference Guide

Dell PowerConnect W-Series ArubaOS 6.1 CLI | Reference Guide rf dot11a-radio-profile | 471
Usage Guidelines
This command configures radios that operate in the 5 GHz frequency band, which includes radios utilizing the
IEEE 802.11a or IEEE 802.11n standard. Channels must be valid for the country configured in the AP regulatory
domain profile (see “ap regulatory-domain-profile” on page 114).
To view the supported channels, use the show ap allowed-channels command.
Examples
The following command configures APs to operate in AM mode for the selected dot11a-radio-profile named
“samplea:”
(host) (config) #rf dot11a-radio-profile samplea mode am-mode
The following command configures APs to operate in high-throughput (802.11n) mode on the
5 Ghz frequency band for the selected dot11a-radio profile named “samplea” and assigns a high-throughout radio
profile named “default-a:”
(host) (config) #rf dot11a-radio-profile samplea
high-throughput-enable
ht-radio-profile default-a
The following command configures a primary channel number of 157 and a secondary channel number of 161 for
40 MHz mode of operation for the selected dot11a-radio profile named “samplea:”
(host) (config) #rf dot11a-radio-profile samplea
channel <157+>
Command History
Command Information
Release Modification
ArubaOS 3.0 Command introduced
ArubaOS 3.3.2 Introduced support for the high-throughput IEEE 802.11n standard.
ArubaOS 3.4 Support for the following parameters:
 Spectrum load balancing
 Spectrum load balancing domain
 RX Sensitivity Tuning Based Channel Reuse
 RX Sensitivity Threshold
 ARM/WIDS Override
ArubaOS 3.4.1 The maximum-distance parameter was introduced.
ArubaOS 3.4.2 The beacon-regulate parameter was introduced.
ArubaOS 6.0 Support for the following parameters:
 am-scan-profile
 cap-reg-eirp
 slb-mode
 slb-update-interval
ArubaOS 6.1 The spectrum-monitoring and slb-threshold parameters were introduced.
Platforms Licensing Command Mode
All platforms Base operating system Config mode on master controllers