Reference Guide

4 | Introduction Dell PowerConnect W-Series ArubaOS 6.1 CLI | Reference Guide
Modified Commands
The following commands were modified in ArubaOS 6.1.
local-factory-cert This command configures the factory-installed certificate for secure
communication between a local controller and a master controller.
netdestination6 This command configures an alias for an IPv6 -only network host, subnetwork, or
range of addresses.
netexthdr This command allows you to edit the packet filter options in the extension header
(EH).
ntp authenticate This command enables or disables NTP authentication
.
ntp authentication-key This command configures a key identifier and secret key and adds them to the
database. NTP authentication works with a symmetric key configured by user. The
key is shared by the client (Dell controller) and an external NTP server.
ntp trusted-key This command configures an additional subset of trusted keys which can be used
for NTP authentication.
remote-node-local-
factory-cert
Configure factory certificates for secure traffic between Remote-Node-Masters
and Remote-Nodes.
show controller-ipv6 This command displays the controller’s IPv6 address and VLAN interface ID.
show ipv6 interface This command displays IPv6-related information on all interfaces.
show ipv6 neighbors This command displays the IPv6 neighbors configured on a VLAN interface.
show ipv6 route This command displays the controller IPv6 routing table.
show local-cert-mac Display the IP, MAC address and certificate configuration of local controllers in a
master-local configuration.
show netexthdr This command displays the IPv6 extension header (EH) types that are denied.
show wms wired-mac Display a summary table of Wireless Management System (wms) wired MAC
information.
tracepath Traces the path of an IPv6 host.
Command Parameter Description
aaa authentication
captive-portal black-list
<black-list> | white-list
<white-list>
Name of an existing black list or white list on an IPv4 or IPv6 network destination.
The black list contains websites (unauthenticated) that a guest cannot access. The
white list contains authenticated websites that a guest can access.
aaa authentication-server
radius source-interface
<vlan>
Associates a VLAN interface with the RADIUS server to allow the group-specific
source interface to override the global configuration.
aaa derivation-rules user
<name> set {role|vlan}
condition dhcp-option
Use DHCP signature matching to assign a role or VLAN to a specific device type.
aaa profile <profile>
devtype-clasification
When the devtype-classification parameter is enabled, the output of the show user
and show user-table commands shows each client’s device type, if that client
device can be identified
aaa profile <profile>
enforce-dhcp
When you enable this option, clients must complete a DHCP exchange to obtain an
IP address.
Command Description