Reference Guide

Table Of Contents
Dell PowerConnect ArubaOS 6.0 Command Line Interface | Reference Guide show remote-node-profile | 986
show remote-node-profile
show remote-node-profile
Description
The output of this command shows Remote Node profile configuration information.
Syntax
Usage Guidelines
This show remote-node-profile command shows the configuration status of a Remote Node profile. To create a
Remote Node profile, use the remote-node-profile command to create a Remote Node profile.
Example
This example shows the configuration status of Remote Node profile named “test.”
Parameter Description
remote-node-profile-
name
Name of the Remote Node profile
(host) #show remote-node-profile ?
<remote-node-profile-name> Profile name
| Output Modifiers
<cr>
(host) #show remote-node-profile test
.......Vlan interface not configured for the controller-ip vlan.
.......No uplink information has been configured.
remote-node-profile test
remote-node-dhcp-pool newpool
pool-type tunnel 0
domain-name mycorp.com
range startip 0.0.0.0 endip 0.0.0.0 hosts 1
!
!