Reference Guide

Dell PowerConnect ArubaOS 6.0 Command Line Interface | Reference Guide show ntp status | 934
Related Commands
To configure an NTP server, use the command ntp server.
Command History
This command was available in ArubaOS 3.0.
Command Information
packets rejected Number of NTP packets rejected because they had an invalid format.
system peer The IP address of the peer NTP server.
system peer mode The peer mode of this remote association:
z Symmetric Active
z Symmetric Passive
z Client
z Server
z Broadcast
leap indicator This parameter indicates whether or not a leap-second should be inserted or removed at
the end of the last day of the current month.
z 00 no warning
z 01 +1 second (following minute has 61 seconds)
z 10 -1 second (following minute has 59 seconds)
stratum The stratum level of the peer
precision The advertised precision of the switch. This value can range from -4 and -20, inclusive.
root distance Total round trip delay to the stratum 1 reference clock.
root dispersion Total dispersion to the stratum 1 reference clock. This value is a cumulative measure of all
errors associated with the network hops and servers between the NTP server and its
stratum 1 server.
reference ID IP address of the remote NTP server
reference time Time when the local system clock was last set or corrected, in NTP timestamp
format.
system flags This parameter displays any flags configured for this NTP entity.
jitter The average magnitude of jitter between several time queries.
stability The average magnitude of offset between several time queries
broadcastdelay The broadcast delay of this NTP server association, in seconds.
authdelay The authentication delay of this NTP server association, in seconds.
Platforms Licensing Command Mode
All platforms Base operating system Enable and Config mode on local and master
controllers
Parameter Description