Reference Guide

Dell PowerConnect ArubaOS 6.0 Command Line Interface | Reference Guide show ip ospf | 858
To display OSPF settings for an individual interface, you must specify a VLAN or tunnel ID number. The
example below displays part of the output of the show ip ospf interface vlan command.
The output may include some or all of the following parameters.
Parameter Description
Vlan <number> Identifies that the interface type and ID are up and functional.
Internet Address Internet address, network mask, and area assigned to the interface.
Router ID Displays the router ID, that the network type is Broadcast, and the cost value.
Transmit Delay Details of the transmit delay, state, and priority.
Designated Router Details of the designated router ID and interface address.
Backup Designated Router ID Details of the backup router ID and interface address.
Timer intervals configured Details of elapse time intervals for Hello, Dead, Transmit (wait), and retransmit.
Neighbor Count Details the number of neighbors and adjacent neighbors.
Tx Stat Counters and statistics for transmitted data.
z Hellos: Number of transmitted hello packets. These packets are sent every hello
interval.
z DbDescr: Number of transmitted database description packets.
z LsReq: Number of transmitted link state request packets.
z LsUpdate: Number of transmitted link state update packets.
z LsAck: Number of transmitted link state acknowledgment packets
z Pkts: Total number of transmitted packets.
Rx Stat Counters and statistics for received data.
z Hellos: Number of received hello packets. These packets are sent every hello
interval.
z DbDescr: Number of received database description packets.
z LsReq: Number of received link state request packets.
z LsUpdate: Number of received link state update packets.
z LsAck: Number of received link state acknowledgment packets
z Pkts: Total number of received packets.
DisCd Number of received packets that are discarded.
BadVer Number of received packets that have bad OSPF version number.
BadNet Number of received packets that belong to different network than the local interface.
BadArea Number of received packets that belong to different area than the local interface.
BadDstAdr Number of received packets that have wrong destination address.
(host) # show ip ospf interface vlan 10
Vlan 3 is up, line protocol is up
Internet Address 3.3.3.1, Mask 255.255.255.0, Area 10.1.1.1
Router ID 10.4.131.227, Network Type BROADCAST, Cost: 1
Transmit Delay is 1 sec, State WAIT, Priority 1
Designated Router id 0.0.0.0, Interface Address 3.3.3.1
Backup designated Router id 0.0.0.0, Interface Address 3.3.3.1
Timer intervals configured, Hello 10, Dead 40, Retransmit 5
Neighbor Count is 0
Tx Stat: Hellos 1 DbDescr 0 LsReq 0 LsUpdate 0 LsAck 0 Pkts 1
Rx Stat: Hellos 0 DbDescr 0 LsReq 0 LsUpdate 0 LsAck 0 Pkts 0
DisCd 0 BadVer 0 BadNet 0 BadArea 0 BadDstAdr 0 BadAuType 0
BadAuth 0 BadNeigh 0 BadPckType 0 BadVirtLink 0
...