Reference Guide

Dell PowerConnect ArubaOS 6.0 Command Line Interface | Reference Guide show ip igmp | 850
The output of this command includes the following parameters:
The following example displays the current IGMP configuration settings for the controller.
The output of this command includes the following parameters:
Parameter Description
VLAN A VLAN ID number.
Addr IP address of a VLAN router.
Netmask Subnet mask for the IP address.
MAC Address MAC destination address.
IGMP Shows if IGMP proxy is enabled or disabled.
Snooping Shows if IGMP snooping is enabled or disabled.
Querier IP address of an IGMP querier.
Destination Traffic destination.
IGMP Proxy Shows if IGMP proxy.
Parameter Description
robustness-variable This variable is increased from its default level of 2 to allow for expected
packet loss on a subnetwork.
query-interval Interval, in seconds, at which the controller sends host-query messages to
the multicast group address 224.0.0.1 to solicit group membership
information.
query-response-interval Maximum time, in .1 second intervals, that can elapse between when the
controller sends a host-query message and when it receives a response. This
must be less than the query-interval.
startup-query-count Number of queries that the controller sends out on startup, separated by
startup-query-interval. The default setting is the value of the robustness-
variable parameter.
startup-query-interval Interval, in seconds, at which the controller sends general queries on startup.
The default value of this parameter is 1/4 of the query-interval.
last-member-query-count Number of group-specific queries that the controller sends before assuming
that there are no local group members.
last-member-query-interval Maximum time, in seconds, that can elapse between group-specific query
messages.
(host) #show ip igmp config
IGMP Config
-----------
Name Value
---- -----
robustness-variable 2
query-interval 125
query-response-interval 100
startup-query-interval 31
startup-query-count 2
last-member-query-interval 10
last-member-query-count 2
version-1-router-present-timeout 400