Reference Guide

Dell PowerConnect ArubaOS 6.0 Command Line Interface | Reference Guide show interface fastethernet | 826
show interface fastethernet
show interface fastethernet <slot/port>
Description
Displays information about a specified fast ethernet port.
Syntax
Examples
The example below shows the output of show interface fastethernet 1/0.
The output of this command includes the following parameters:
Parameter Description
access-group Displays access groups configured on this interface.
counters Displays L2 interface counters for the specified interface.
switchport Displays L2 interface information.
untrusted-vlan Displays port member vlan untrusted status.
xsec Displays xsec configuration.
Parameter Description
FE 1/0 is... Displays the status of the specified port.
line protocol is... Displays the status of the line protocol on the specified port.
Hardware is.... Describes the hardware interface type.
address is... Displays the MAC address of the hardware interface.
Description The port type, name, and connector type.
Encapsulation Encapsulation method assigned to this port.
loopback... Displays whether or not loopback is set.
Configured Configured transfer operation and speed.
Negotiated Negotiated transfer operation and speed.
MTU bytes MTU size of the specified port in bytes.
FE 1/0 is up, line protocol is up
Hardware is FastEthernet, address is 00:0B:86:51:14:D1 (bia 00:0B:86:51:14:D1)
Description: fe1/0
Encapsulation ARPA, loopback not set
Configured: Duplex ( AUTO ), speed ( AUTO )
Negotiated: Duplex (Full), speed (100 Mbps)
MTU 1500 bytes, BW is 100 Mbit
Last clearing of "show interface" counters 15 day 21 hr 34 min 53 sec
link status last changed 15 day 21 hr 32 min 16 sec
1122463 packets input, 196293018 bytes
Received 661896 broadcasts, 0 runts, 0 giants, 0 throttles
0 input error bytes, 0 CRC, 0 frame
661881 multicast, 460567 unicast