Reference Guide

762 | show datapath Dell PowerConnect ArubaOS 6.0 Command Line Interface | Reference Guide
Usage Guidelines
Use the show datapath command to display various datapath statistics for debugging purposes.
counters Display the current and high water mark amount of 802.11 associated wireless devices on
an Dell controller. Values output from this command represent the water-marks since the
last boot of the controller. This is the same value obtainable from the Num Associations
output from the show stm connectivity command.
mac <macaddr> Hardware address, in hexadecimal format.
tcp Displays contents of the tcp tunnel table. This command displays all tcp tunnels that are
terminated by the controller,
app <app> Name of the application.
counters Displays the tcp tunnel statistics.
tunnel Displays the tcp tunnel table.
table This command displays the Datapath Station Table Statistics detail.
Display all associated wireless devices on the Dell controller with their
corresponding AP BSSID and VLAN ID.
Displays the wireless device is associated with the correct encryption type (if the device is
associated to an AP BSSID that has encryption enabled and verifies whether the Dell
controller is having a problem in decrypting the wireless device’s frames.
tunnel Displays contents of the datapath tunnel table. This command displays all the tunnels that
are terminated by the controller, including Dell APs’ GRE tunnels. For example, a GRE
tunnel is created and terminated on the Dell controller for every SSID/BSSID configured on
the Dell AP.
counters Tunnel counters.
table Tunnel table statistics.
user Displays datapath user statistics such as current entries, pending deletes, high water
mark, maximum entries, total entries, allocation failures, invalid users and maximum link
length.
ap-name <ap-name> Name of AP.
counters User counters.
ip-addr <ip-address> IP address of the AP.
table User table statistics.
utilization Displays the current CPU utilization of all datapath CPUs.
vlan Displays VLAN table information such as VLAN memberships inside the datapath including
L@ tunnels which tunnel L2 traffic.
ap-name <ap-name> Name of the AP.
ip-addr <ip-address> IP address of AP.
table Displays VLAN number, flag, port and datapath VLAN multicast entries.
wifi-reassembly
counters
Displays wifi reassembly counters including CPU, current entries, high water-mark,
maximum entries, total entries and allocation failures.
wmm counters Displays VOIP statistics including the number of uplink and downlink resets.
Parameter Description