Reference Guide

Dell PowerConnect ArubaOS 6.0 Command Line Interface | Reference Guide show ap system-profile | 706
show ap system-profile
show ap system-profile <profile>
Description
Show an AP’s system profile settings.
Syntax
Examples
The output of the command below shows the current configuration settings for the default system profile.
The output of this command includes the following information:
Parameter Description
<profile> Name of a system profile.
Column Description
LMS IP The IP address of the local management switch (LMS)—the Dell controller which is
responsible for terminating user traffic from the APs, and processing and forwarding the
traffic to the wired network.
Backup LMS IP For multi-controller networks, this parameter displays the IP address of a backup to the IP
address specified with the lms-ip parameter.
LMS Preemption When this parameter is enabled, the local management switch automatically reverts to the
primary LMS IP address when it becomes available.
(host) #show ap system profile default
AP system profile "default"
---------------------------
Parameter Value
--------- -----
LMS IP 192.0.2.90
Backup LMS IP N/A
LMS Preemption Disabled
LMS Hold-down Period 600 sec
Master controller IP address N/A
LED operating mode (AP-12x only) normal
RF Band a
Double Encrypt Disabled
Native VLAN ID 1
SAP MTU N/A
Bootstrap threshold 8
Request Retry Interval 10 sec
Maximum Request Retries 10
Dump Server 192.0.2.41
Telnet Enabled
SNMP sysContact N/A
RFprotect Server IP N/A
RFprotect Backup Server IP N/A
AeroScout RTLS Server 192.0.2.32.104:1411
RTLS Server configuration N/A
Heartbeat DSCP 0
Session ACL N/A
Corporate DNS Domain N/A
Maintenance Mode Disabled
Remote-AP Local Network Access Disabled