Reference Guide

703 | show ap spectrum monitors Dell PowerConnect ArubaOS 6.0 Command Line Interface | Reference Guide
show ap spectrum monitors
show ap spectrum monitors
Description
This command shows a list of APs terminating on the controller that are currently configured as spectrum
monitors.
Syntax
No parameters
Examples
The output of this example shows that the 802.11a radio on a spectrum monitor named ap123 is sending
spectrum analysis data to a client with the IP address 10.240.16.177.
The output of this command includes the following information:
Command History
Introduced in ArubaOS 6.0.
Command Information
Column Description
AP name Name of an AP configured as a spectrum monitor
Phy The radio’s PHY type. Possible values are A for 802.11a and G for 802.11b/g,
Band Spectrum band that the spectrum monitor radio is currently monitoring. Possible values
are:
z 2GHz
z 5GHz-lower
z 5GHz-middle
z 5GHz-upper
Client IP IP address of the client to which the spectrum monitor is sending data.
Subscribe time Time at which the spectrum monitor was connected to the client.
Platforms Licensing Command Mode
All platforms Base operating system Enable or Config mode on master or local
controllers
(host)# show ap spectrum debug monitors
List of Sensors
---------------
AP name Phy Band Client IP Subscribe Time
------- --- ---- --------- --------------
ap123 G 2GHz 10.240.16.177 2010-06-09 04:51:38 PM
ap123 A 5GHz-upper 10.240.16.177 2010-06-09 04:51:34 PM
Num Sensors:2