Reference Guide

657 | show ap radio-database Dell PowerConnect ArubaOS 6.0 Command Line Interface | Reference Guide
show ap radio-database
show ap radio-database [band a|g] [group <group>] [mode access-point|air-
monitor|disabled|ht|ht-40mhz|legacy|sap-monitor] [sort-by ap-group|ap-ip|ap-name|ap-
type|switch-ip] [sort-direction ascending|descending] [start <start>] [switch <switch-
ip-addr>]
Description
Show radio information for Access Points visible to this controller.
Syntax
Parameter Description
band Show only APs with a radio operating in the specified band.
a Show only APs with a radio operating in the 802.11a band (5 GHz).
g Show only APs with a radio operating in the 802.11g band (2.4 GHz).
group <group> Show only APs associated with the specified AP group
mode Show only APs with a radio operating in the specified mode.
access-point Show only APs operating as access points
air-monitor Show only APs operating as air monitors.
disabled Show only disabled APs.
ht Show only high-throughput APs.
ht-40mhz Show only 40 Mhz high-throughput APs
legacy Show only legacy (not high-throughput) APs.
sap-monitor Show only APs operating as SAP monitors
sort-by Sort the output of this command by a specific data column
ap-group Sort the output of this command by AP group name
ap-ip Sort the output of this command by AP IP address
ap-name Sort the output of this command by AP name
ap-type Sort the output of this command by AP model type.
switch-ip Sort the output of this command by controller ip address
sort-direction Select a sort direction for the output of this command
ascending Sort the output in ascending order.
descending Sort the output in descending order.
start Start displaying the output of this command at a chosen index number by entering the index
number of the AP at which command output should start.
switch <switch-ip-
addr>
Display information for APs associated with a specific controller by entering the IP address of
that controller.