Reference Guide

Dell PowerConnect ArubaOS 6.0 Command Line Interface | Reference Guide show ap monitor debug | 644
The output of this command includes the following information:
Column Description
bssid The Basic Service Set Identifier (BSSID) for the AP. This is usually the AP’s MAC address.
scan Indicates whether or not if active scanning is enabled on this AP.
monitor Indicates whether the AP radio is currently enabled or disabled.
probe-type This parameter displays one of the following options to show the AP is configured.
z sap: Default AP setting.
z am: AP is configured as an Air Monitor.
z m-portal: AP is configured as a Mesh portal.
z m-point: AP is configured as a Mesh point.
task This parameter displays one of the following options to show the radio’s current task:
z scan: AP is scanning other channels.
z tuned: AP is tuned on one channel.
z locate: AP has been asked to locate a specific AP or client.
z pcap: The AP is enabled with the Packet Capture feature.
channel The radio channel currently used by an AP’s WLAN interface.
pkts Number of packets seen on the interface.
mac MAC address for the AP’s wired interface.
ip The AP’s IP address.
gw-ip IP address for the AP’s gateway.
gw-mac MAC address for the AP’s gateway.
status Shows if the interface is currently enabled or disabled.
pkts Number of packets seen on the AP’s wired interface.
macs Number of MAC addresses in the Wired MAC table for that interface.
gw-macs Number of MAC addresses in the Wired MAC table for that interface.
tagged-pkts Number VLAN-tagged packets sent to that interface.
vlan The VLAN ID for the packets sent to that interface.
Packets read Number of packets read by the AP since it was last reset.
Bytes read Number of bytes read by the AP since it was last reset.
Num Intercepts Number of interrupts from the AP’s driver.
Num Buffer Overflows Number of times excessive traffic has filled the AP’s buffers.
Max PPS Maximum throughput rate seen on the interface, in packets per second.
Cur PPS Current throughput rate seen on the interface, in packets per second.
Max PPI Maximum interrupt rate seen on the interface, in interrupts per second.
Cur PPI Current interrupt rate seen on the interface, in interrupts per second.
Uptime Number of seconds since the AP was last reset.
LMS IP IP address of the AP’s local controller.
Master IP IP address of the AP’s master controller.
AP type AP model type.