Reference Guide

6 |Introduction Dell PowerConnect ArubaOS 6.0 Command Line Interface | Reference Guide
Deprecated Commands
The following commands were deprecated in ArubaOS 6.0.
About this Guide
This guide describes the ArubaOS command syntax. The commands in this guide are listed alphabetically.
The following information is provided for each command:
z Command Syntax—The complete syntax of the command.
show voice client-status The sta parameter was introduced.
show voice trace The trace output included the BSSID parameter.
show whitelist-db cpsec-local-
switch-list
The cpsec-local-ctrlr-list parameter was modified to cpsec-local-switch-list
show whitelist-db cpsec-local-
switch-list
The cpsec-master-ctrlr-list parameter was modified to cpsec-master-switch-list
spanning-tree
(Configuration Interface)
Added support for PVST+ and VLAN range
stm purge-blacklist-
client
Clear the entire client blacklist.
uplink Set the priority of the wired uplink. Each uplink type has an associated priority;
wired ports having the highest priority by default.
vlan <id> wired aaa-
profile <profile>
Assign an AAA profile to a VLAN to enable role-based access for wired clients
connected to an untrusted VLAN or port on the controller. This parameter applies to
wired clients only.
voice rtcp-inactivity This was part of the voip command in the earlier version. voip command is now
deprecated.
voice sip-midcall-req-
timeout
This was part of the voip command in the earlier version. voip command is now
deprecated.
whitelist-db cpsec add The controller-cert parameter was modified to switch-cert.
whitelist-db cpsec modify The cpsec-local-ctlr-list parameter was modified to cpsec-local-switch-list
whitelist-db cpsec-local-switch-list The cpsec-local-ctlr-list parameter was modified to cpsec-local-switch-list
whitelist-db cpsec-master-switch-list The cpsec-master-ctrlr-list parameter was modified to cpsec-master-switch-list
wlan virtual-ap <profile>
steering-mode band-
balancing|force-
5ghz|prefer-5ghz
Band steering supports three different band steering modes.
wms ap bssid mode Updated the mode names and deprecated the dos mode.
Command Description
show ap debug
association-failure
(deprecated)
Display association failure information that can be used to troubleshoot problems
on an AP
show user_session_count
(deprecated)
Show the number of users using an ESSID for different time intervals.
Command Parameter Description