Reference Guide

Dell PowerConnect ArubaOS 6.0 Command Line Interface | Reference Guide show ap config | 552
Related Commands
Command History
Introduced in ArubaOS 3.0.
Command Information
VoIP Send SIP 100 Trying If enabled, the AP sends SIP 100 - trying messages to a call originator to indicate that the
call is proceeding. This is useful when the SIP invite may be redirected through a number
of servers before reaching the controller.
VoIP Disconnect Extra
Call
If enabled, the AP disconnects calls that exceed the high capacity threshold by sending a
deauthentication frame.
VOIP TSPEC Enforcement Shows if validation of TSPEC requests for call admission controls is enabled or disabled.
VOIP TSPEC Enforcement
Period
Displays the maximum time for the station to start a call after the TSPEC request.
VoIP Drop SIP Invite and
send status code (client)
Displays the status code sent to the client when a SIP Invite is dropped.
z 480: Temporary Unavailable
z 486: Busy Here
z 503: Service Unavailable
z none: Don't send SIP status code
VoIP Drop SIP Invite and
send status code (server)
Displays the status code sent to the server when a SIP Invite is dropped.
z 480: Temporary Unavailable
z 486: Busy Here
z 503: Service Unavailable
z none: Don't send SIP status code
Command Description Mode
ap system-profile
rf dot11g-radio-profile
rf arm-profile
rf ht-radio-profile
wlan ht-ssid-profile
wlan virtual-ap
wlan voip-cac-profile
The output of the show ap config command displays the
content of the profile settings for an individual AP or AP group.
Use the commands displayed in the column to the left to
configure these parameters.
Enable and Config
modes
Platforms Licensing Command Mode
All platforms Base operating system Enable or Config mode on master controllers
Parameter Description