Reference Guide

545 |show ap config Dell PowerConnect ArubaOS 6.0 Command Line Interface | Reference Guide
The output of this command includes the following parameters.
Parameter Description
LMS IP The IP address of the local management switch (LMS)—the Dell controller which is
responsible for terminating user traffic from the APs, and processing and forwarding the
traffic to the wired network.
Backup LMS IP For multi-controller networks, this parameter displays the IP address of a backup to the
IP address specified with the lms-ip parameter.
LMS Preemption When this parameter is enabled, the local management switch automatically reverts to
the primary LMS IP address when it becomes available.
LMS Hold-down Period Time, in seconds, that the primary LMS must be available before an AP returns to that
LMS after failover.
Master controller IP
address
For multi-controller networks, this parameter displays the IP address of the master
controller.
RF Band For dual-band radios, this parameter displays the RF band in which the AP should
operate:
z g = 2.4 GHz
z a = 5 GHz
Double Encrypt This parameter applies only to remote APs. Double encryption is used for traffic to and
from a wireless client that is connected to a tunneled SSID. When enabled, all traffic is
re-encrypted in the IPsec tunnel. When disabled, the wireless frame is only encapsulated
inside the IPsec tunnel.
Native VLAN ID Native VLAN for bridge mode virtual APs (frames on the native VLAN are not tagged with
802.1q tags).
SAP MTU Maximum Transmission Unit (MTU) size, in bytes. This value describes the greatest
amount of data that can be transferred in one physical frame.
Bootstrap threshold Number of consecutive missed heartbeats on a GRE tunnel (heartbeats are sent once per
second on each tunnel) before an AP rebootstraps. On the controller, the GRE tunnel
timeout is 1.5 x bootstrap-threshold; the tunnel is torn down after this number of seconds
of inactivity on the tunnel.
Request Retry Interval Interval, in seconds, between the first and second retries of AP-generated requests. If
the configured interval is less than 30 seconds, the interval for subsequent retries is
increased up to 30 seconds.
Maximum Request Retries Maximum number of times to retry AP-generated requests, including keepalive
messages. After the maximum number of retries, the AP either reboots or tries the IP
address specified by the backup LMS IP address (if configured).
Keepalive Interval Time, in seconds, between keepalive messages from the AP
Dump Server (For debugging purposes.) Displays the server to receive the core dump generated if an
AP process crashes.
Telnet Reports whether telnet access the AP is enabled or disabled.
SNMP sysContact SNMP system contact information.
RFprotect Server IP The IP address of the RFprotect server for this AP or group
RFprotect Backup Server
IP
The IP address of the RFprotect backup server for this AP or group
AeroScout RTLS Server Displays whether or not the AP will send RFID tag information to an AeroScout real-time
asset location (RTLS) server.
Ortronics Walljack Displays whether the external Ethernet port on the Ortronics Wi-Jack Duo AP is enabled
or disabled.