Reference Guide

539 | show ap bss-table Dell PowerConnect ArubaOS 6.0 Command Line Interface | Reference Guide
Command History
Introduced in ArubaOS 3.0.
Command Information
s/p The controller port used by the AP, in the format <slot>/<port>.
The <slot> number is always 1. The <port> parameter refers to the network interfaces that are
embedded in the front panel of the W-3000 Controller Series Multi-Service Controller. Port numbers
start at 0, from the left-most position.
ip IP address of an AP.
phy An AP radio type. Possible values are:
z a—802.11a
z a-HT—802.11a high throughput
z g— 802.11g
z g-HT—802.11g high throughput
type Shows whether the AP is working as an access point (AP) or air monitor (AM).
ch/EIRP/max-EIRP Radio channel used by the AP/current effective Isotropic Radiated Power (EIRP) /maximum EIRP.
cur-cl Current number of clients on the AP.
ap name Name of the AP.
in-t(s) Number of seconds that an AP has been inactive.
tot-t An AP’s total active time, in seconds.
mtu Maximum Transmission Unit (MTU) size, in bytes. This value describes the greatest amount of data
that can be transferred in one physical frame.
acl-state An access control list (ACL) can enable or disable an AP during specific time ranges.
z Disabled: An ACL with time restrictions is currently disabled (so the AP is enabled).
z Enabled: An ACL with time restrictions is currently enabled (so the AP is disabled).
z This data column will display a dash (-) if no ACLs are currently configured for the AP.
Platforms Licensing Command Mode
All platforms Base operating system Enable or Config mode on master controllers
Column Description