Reference Guide

523 |show ap arm rf-summary Dell PowerConnect ArubaOS 6.0 Command Line Interface | Reference Guide
show ap arm rf-summary
show ap arm rf-summary {ap-name <ap-name>}|{bssid <bssid>}|{ip-addr <ip-addr>}
Description
Show the state and statistics for all channels being monitored by an individual AP.
Syntax
Examples
The output of this command shows detailed information for the individual channels being monitored and
statistics for each AP interface. Use this command verify an AP’s RF health, or to determine why multiple APs in
the same area are on the same channel.
The output of this command includes the following information:
Parameter Description
ap-name <ap-name> Show channel data for an AP with a specific name.
bssid <bssid> Show channel data for a specific Basic Service Set Identifier (BSSID) on an AP. An AP’s BSSID
is usually the AP’s MAC address.
ip-addr <ip-addr> Show channel data for an AP with a specific IP address. Enter the IP address in dotted-
decimal format.
Parameter Description
channel Number of a radio channel used by the AP.
(host)# show ap arm rf-summary ap-name ap21
Channel Summary
---------------
channel retry low-speed non-unicast frag bwidth phy-err mac-err noise cov-idx intf_idx
------- ----- --------- ----------- ---- ------ ------- ------- ----- ------- --------
1 0 0 0 0 0 0 0 0 1/1 27/12//12/0
48 0 0 0 0 0 0 0 0 0/0 0/0//4/1
165 5 3 3 42 720 0 1 112 10/0 41/0//0/1
6 0 100 50 0 0 0 12 100 10/0 60/10//0/4
11 0 0 0 0 0 0 0 0 4/2 29/13//17/0
149 0 0 0 0 0 0 0 0 0/0 0/0//5/0
36 0 0 0 0 0 0 0 0 0/0 0/0//20/1
153 0 0 0 0 0 0 0 0 0/0 0/0//0/2
40 0 0 0 0 0 0 0 0 0/0 0/0//2/7
44 0 0 0 0 0 0 0 0 0/0 0/0//4/2
Interface Name :wifi0
Current ARM Assignment :165/21
Target Coverage Index :10
Covered channels a/g :0/0
Free channels a/g :7/0
ARM Edge State :enable
Last check channel/pwr :22m:12s/9m:17s
Last change channel/pwr :22m:12s/16m:55s
Next Check channel/pwr :0s/2m:41s
Interface Name :wifi1
Current ARM Assignment :6/6
Target Coverage Index :10
Covered channels a/g :0/2
Free channels a/g :0/1
ARM Edge State :enable
Last check channel/pwr :7h:53m:19s/2m:21s