Reference Guide

Dell PowerConnect ArubaOS 6.0 Command Line Interface | Reference Guide rf dot11g-radio-profile | 406
interference-
immunity
Set a value for 802.11 Interference Immunity. This
parameter sets the interference immunity on the 2.4 Ghz
band.
The default setting for this parameter is level 2. When
performance drops due to interference from non-802.11
interferers (such as DECT or Bluetooth devices), the level
can be increased up to level 5 for improved performance.
However, increasing the level makes the AP slightly “deaf”
to its surroundings, causing the AP to lose a small amount
of range.
The levels for this parameter are:
z Level-0: no ANI adaptation.
z Level-1: noise immunity only.
z Level-2: noise and spur immunity. This is the default
setting
z Level-3: level 2 and weak OFDM immunity.
z Level-4: level 3 and FIR immunity.
z Level-5: disable PHY reporting.
NOTE: Do not raise the noise immunity feature’s default
setting if the channel-reuse-threshold feature is also
enabled. A level-3 to level-5 Noise Immunity setting is not
compatible with the Channel Reuse feature.
Level-0 - Level-5 Level-2
maximum-distance Maximum distance between a client and an AP or between
a mesh point and a mesh portal, in meters. This value is
used to derive ACK and CTS timeout times. A value of 0
specifies default settings for this parameter, where
timeouts are only modified for outdoor mesh radios which
use a distance of 16km.
The upper limit for this parameter varies, depending on the
20/40 MHz mode for a 2.4GHz frequency band radio:
z 20MHz mode: 54km
z 40MHz mode: 24km
Note that if you configure a value above the supported
maximum, the maximum supported value will be used
instead. Values below 600m will use default settings.
0-24km (40MHz
mode)
0-54km (20MHz
mode)
0 meters
mgmt-frame-throttle-
interval
Averaging interval for rate limiting management frames in
seconds. Zero disables rate limiting.
Note: This parameter only applies to AUTH and ASSOC/RE-
ASSOC management frames.
0-60 1 second
interval
mgmt-frame-throttle-
limit
Maximum number of management frames allowed in each
throttle interval.
NOTE: This parameter only applies to AUTH and ASSOC/RE-
ASSOC management frames.
0-999999 20 frames
per interval
mode One of the operating modes for the AP. ap-mode
ap-mode Device provides transparent, secure, high-speed data
communications between wireless network devices and
the wired LAN.
am-mode Device behaves as an air monitor to collect statistics,
monitor traffic, detect intrusions, enforce security policies,
balance traffic load, self-heal coverage gaps, etc.
spectrum-mode Device operates as an spectrum monitor, and can send
spectrum analysis data to a desktop or laptop client.
no Negates any configured parameter. — —
radio-enable Enables or disables radio configuration. — enabled
Parameter Description Range Default