Reference Guide

Dell PowerConnect ArubaOS 6.0 Command Line Interface | Reference Guide rf dot11a-radio-profile | 402
The following command configures APs to operate in high-throughput (802.11n) mode on the
5 Ghz frequency band for the selected dot11a-radio profile named “samplea” and assigns a high-throughout radio
profile named “default-a:”
(host) (config) #rf dot11a-radio-profile samplea
high-throughput-enable
ht-radio-profile default-a
The following command configures a primary channel number of 157 and a secondary channel number of 161 for
40 MHz mode of operation for the selected dot11a-radio profile named “samplea:”
(host) (config) #rf dot11a-radio-profile samplea
channel <157+>
Command History
Command Information
Release Modification
ArubaOS 3.0 Command introduced
ArubaOS 3.3.2 Introduced support for the high-throughput IEEE 802.11n standard.
ArubaOS 3.4 Support for the following parameters:
z Spectrum load balancing
z Spectrum load balancing domain
z RX Sensitivity Tuning Based Channel Reuse
z RX Sensitivity Threshold
z ARM/WIDS Override
ArubaOS 3.4.1 The maximum-distance parameter was introduced.
ArubaOS 3.4.2 The beacon-regulate parameter was introduced.
ArubaOS 6.0 Added support to configure an Air Monitor (AM) scanning profile (am-scan-profile)
Platforms Licensing Command Mode
All platforms Base operating system Config mode on master controllers