Reference Guide

Dell PowerConnect ArubaOS 6.0 Command Line Interface | Reference Guide rf dot11a-radio-profile | 400
maximum-distance Maximum distance between a client and an AP or
between a mesh point and a mesh portal, in meters. This
value is used to derive ACK and CTS timeout times. A
value of 0 specifies default settings for this parameter,
where timeouts are only modified for outdoor mesh
radios which use a distance of 16km.
The upper limit for this parameter varies, depending on
the 20/40 MHz mode for a 5 GHz frequency band radio:
z 20MHz mode: 58km
z 40MHz mode: 27km
Note that if you configure a value above the supported
maximum, the maximum supported value will be used
instead. Values below 600m will use default settings.
0-57km (40MHz
mode)
0-27km
(20MHz mode)
0 meters
mgmt-frame-throttle-
interval
Averaging interval for rate limiting management frames
in seconds. Zero disables rate limiting.
Note: This parameter only applies to AUTH and ASSOC/
RE-ASSOC management frames.
0-60 1 second
interval
mgmt-frame-throttle-
limit
Maximum number of management frames allowed in
each throttle interval.
NOTE: This parameter only applies to AUTH and ASSOC/
RE-ASSOC management frames.
0-999999 20 frames per
interval
mode One of the operating modes for the AP. ap-mode
ap-mode Device provides transparent, secure, high-speed data
communications between wireless network devices and
the wired LAN.
am-mode Device behaves as an air monitor to collect statistics,
monitor traffic, detect intrusions, enforce security
policies, balance traffic load, self-heal coverage gaps,
etc.
spectrum-mode Device operates as an spectrum monitor, and can send
spectrum analysis data to a desktop or laptop client.
no Negates any configured parameter. — —
radio-enable Enables or disables radio configuration. — enabled
slb-mode
channel|radio
SLB Mode allows control over how to balance clients.
Slect one of the following optoins
z channel: Channel-based load-balancing balances
clients across channels. This is the default load-
balancing mode
z radio: Radio-based load-balancing balances clients
across APs
channel
slb-update-interval
<secs>
Specify how often spectrum load balancing calculations
are made (in seconds). The default value is 30 seconds.
1-2147483647
seconds
30 seconds
Parameter Description Range Default