Reference Guide

4 |Introduction Dell PowerConnect ArubaOS 6.0 Command Line Interface | Reference Guide
show ap spectrum
debug fft
Save FFT (Fast Fourier Transform) power data to a file on the spectrum monitor.
show ap spectrum
debug status
This command shows detailed status and statistics for a spectrum monitor.
show ap spectrum
device-history
This command shows the history of the last 256 non-Wi-Fi devices.
show ap spectrum
device-summary
This command shows the numbers of wi-fi and non-Wi-Fi device types on each channel
monitored by a spectrum monitor.
show ap spectrum
interference-power
This command shows the interference power detected by a 802.11a or 80211g radio on a
spectrum monitor.
show ap spectrum
monitors
This command shows a list of APs terminating on the controller that are currently configured
as spectrum monitors.
show ap spectrum-
load-balancing
Show spectrum load balancing information for an AP with this feature enabled.
show master-
configpending
Displays the list of global commands which are not saved and are not sent to the local
controller.
show remote-node Shows configuration and other information about the remote node.
show remote-node-
profile
The output of this command shows Remote Node profile configuration information.
show remote-node-
dhcp-pool
The output of this command lists shows Remote Node DHCP pool summary information.
show voice
configurations
Displays the details of the voice related configurations on your controller.
show voice logging Displays the MAC address of the voice client that has logging enabled.
show voice real-
time-analysis
Displays the call quality parameters based on the call quality analysis on the RTP media
streams for voice calls.
show voice real-
time-analysis-
config
Displays the status of Real Time Call Quality Analysis configuration.
show voice sip Displays the SIP settings on the controller.
show voice sip-
midcall-req-timeout
Displays the status of the SIP mid-call request timeout configuration on the controller.
spanning-tree mode Set the spanning tree mode to either Rapid Spanning Tree (802.1w) or PVST+ (Per VLAN
Spanning Tree).
spanning-tree vlan
(PVST+)
Configure PVST+ on a VLAN.
spanning-tree vlan
range (PVST+)
Configure PVST+ on a VLAN.
vlan-bwcontract-
explist
Use this command to add entries to or remove entries from the MAC exception list for
bandwidth contracts on broadcast/multicast traffic.
voice dialplan-
profile
This command allows you to create a dial plan profile and configure dial plans to the profile.
voice logging This command allows you to enable logging for a voice client.
voice real-time-
config
This command enables the controller to analyze the call quality of the voice calls based on
the RTP media streams.
Command Description