Reference Guide

376 |provision-ap Dell PowerConnect ArubaOS 6.0 Command Line Interface | Reference Guide
4. Use the reprovision all option to provision the APs in the provisioning-ap-list with the values in provisioning-
params workspace. All APs in the provisioning-ap-list automatically reboot.
The following are useful commands when provisioning one or more APs:
z show|clear provisioning-ap-list displays or clears the APs that will be provisioned.
z show|clear provisioning-params displays or resets values in the provisioning-params workspace.
z show ap provisioning shows the provisioning parameters an AP is currently using.
Example
The following commands change the IP address of the master controller on the AP:
(host) (config) #provision-ap
read-bootinfo ap-name lab103
show provisioning-ap-list
copy-provisioning-params ap-name lab103
master 10.100.102.210
reprovision ap-name lab103
Command History
Command Information
Release Modification
ArubaOS 3.0 Command introduced
ArubaOS 3.2 Introduced support for the mesh parameters, additional antenna parameters, and AP
location parameters.
ArubaOS 3.4 Introduced support for the following parameters:
z installation
z mesh-sae
z set-ikepsk-by-addr
z usb-dev
z usb-dial
z usb-init
z usb-passwd
z usb-tty
z usb-type
z usb-user
ArubaOS 5.0 The mesh-sae parameter no longer has the sae-default option. Use the sae-disable option
to return this parameter to its default disabled setting.
ArubaOS 6.0 The uplink-vlan parameter was introduced.
Platforms Licensing Command Mode
All platforms, except for the parameters
noted in the Syntax table.
Base operating system, except for the
parameters noted in the Syntax table.
Config mode on master controllers