Reference Guide

Table Of Contents
Dell PowerConnect ArubaOS 6.0 Command Line Interface | Reference Guide interface vlan | 253
Syntax
Parameter Description Range Default
vlan VLAN ID number. 1-4094
bandwidth-contract Name of the bandwidth contract to be applied to this VLAN
interface. When applied to a VLAN, the contract only limits
multicast traffic and does not affect other data. Use the aaa
bandwidth-contract command to configure a bandwidth
contract.
——
bcmc-optimization Enables broadcast and multicast traffic optimization to
prevent flooding of broadcast and multicast traffic on
VLANs.
——
description String that describes this interface. 802.1Q VLAN
ip Configures IPv4 for this interface.
address Configures the IP address for this interface, which can be
one of the following:
<ipaddr> <netmask>
dhcp-client: use DHCP to obtain the IP address
pppoe: use PPPoE to obtain the IP address
——
helper-address IP address of the DHCP server for relaying DHCP requests
for this interface. If the DHCP server is on the same
subnetwork as this VLAN interface, you do not need to
configure this parameter.
——
igmp Enables IGMP and/or IGMP snooping on this interface.
local-proxy-arp Enables local proxy ARP.
nat inside Enables source network address translation (NAT) for all
traffic routed from this VLAN.
——
ospf Define an OSPF area. See ip ospf for complete details
on this command.
——
pppoe-max-segment-
site
Configures the TCP maximum segment size in bytes. 128
pppoe-password Configures the PAP password on the PPPoE Access
Concentrator for the switch.
1–80
pppoe-service-name Configures the PPPoE service name. 1–80
pppoe-username Configures the PAP username on the PPPoE Access
Concentrator for the switch.
1–80
routing Enables layer-3 forwarding on the VLAN interface. To
disable layer-3 forwarding, you must configure the IP
address for the interface and specify no ip routing.
(enabled)
ipv6 Configures IPv6 for this interface.
mld Enables Multicast Listener Discovery (MLD) on this
interface.
——
snooping Enables MLD snooping on this interface.
no Negates any configured parameter.
mtu MTU setting for the VLAN. 1024-1500
operstate up Set the state of the interface to be up.
shutdown Causes a hard shutdown of the interface.