Reference Guide

Table Of Contents
Dell PowerConnect ArubaOS 6.0 Command Line Interface | Reference Guide interface port-channel | 243
Syntax
Parameter Description Range Default
port-channel ID number for this port channel. 0-7
add Adds the specified FastEthernet or GigabitEthernet interface to the
port channel.
You cannot specify both FastEthernet and GigabitEthernet
interfaces for the same port channel.
——
del Deletes the specified Fastethernet or Gigabitethernet interface to
the port channel.
——
ip access-group Applies the specified access control list (ACL) to the interface. Use
the ip access-list command to configure an ACL.
NOTE: This command requires the PEFNG license.
——
in Applies ACL to interface’s inbound traffic.
out Applies ACL to interface’s outbound traffic.
session Applies session ACL to interface and optionally to a selected VLAN
associated with this port.
——
no
Negates any configured parameter.
shutdown
Causes a hard shutdown of the interface.
spanning-tree
Enables spanning tree.
portfast
Enables forwarding of traffic from the interface.
switchport
Sets switching mode parameters for the interface.
access vlan
Sets the interface as an access port for the specified VLAN. The
interface carries traffic only for the specified VLAN.
——
mode
Sets the mode of the interface to access or trunk mode only.
trunk
Sets the interface as a trunk port for the specified VLANs. A trunk
port carries traffic for multiple VLANs using 802.1q tagging to mark
frames for specific VLANs. You can include all VLANs configured on
the controller, or add or remove specified VLANs.
——
native
Specifies the native VLAN for the trunk mode interface. Frames on
the native VLAN are not 802.1q tagged.
——
trusted
Set this interface and range of VLANs to be trusted. VLANs not
included in the trusted range of VLANs will be, by default, untrusted.
Trusted ports and VLANs are typically connected to internal
controlled networks, while untrusted ports connect to third-party
APs, public areas, or other networks to which access controls
should be applied. When Dell APs are attached directly to the
controller, set the port to be trusted.
disabled