Reference Guide

Table Of Contents
Dell PowerConnect ArubaOS 6.0 Command Line Interface | Reference Guide audit-trail | 132
audit-trail
audit-trail [all]
Description
This command enables an audit trail.
Syntax
Usage Guidelines
By default, audit trail is enabled for all commands in configuration mode. Use the show audit-trail command to
display the content of the audit trail.
Example
The following command enables an audit trail:
(host) (config) #audit-trail
Command History
This command was introduced in ArubaOS 3.0.
Command Information
Parameter Description
all Enables audit trail for all commands, including enable mode commands. The audit-trail
command without this option enables audit trail for all commands in configuration mode.
Platforms Licensing Command Mode
All platforms Base operating system Config mode on master controllers