Reference Guide

Dell PowerConnect ArubaOS 6.0 Command Line Interface | Reference Guide apboot | 127
apboot
apboot {all [global|local]|ap-group <group> [global|local]|ap-name <name>|ip-addr
<ipaddr>|wired-mac <macaddr>}
Description
This command reboots the specified APs.
Syntax
Usage Guidelines
You should not normally need to use this command as APs automatically reboot when you reprovision them. Use
this command only when directed to do so by your Dell representative.
Example
The following command reboots a specific AP:
(host)(config)# apboot ap-name Building3-Lobby
Command History
This command was introduced in ArubaOS 3.0.
Command Information
Parameter Description Default
all Reboot all APs. all
global Reboot APs on all controllers. global
local Reboot only APs registered on this controller. This is the
default.
local
ap-group Reboot APs in a specified group. ap-group
global Reboot APs on all controllers. global
local Reboot only APs registered on this controller. This is the
default.
local
ap-name Reboot the AP with the specified name. ap-name
ip-addr Reboot the AP at the specified IP address. ip-addr
wired-mac Reboot the AP at the specified MAC address. wired-mac
Platforms Licensing Command Mode
All platforms Base operating system Enable and Config mode on master controllers