Reference Guide

118 | ap system-profile Dell PowerConnect ArubaOS 6.0 Command Line Interface | Reference Guide
rap-dhcp-lease The amount of days that the assigned IP address is valid for
the client. Specify the lease in <days>.
0 indicates the IP address is always valid; the lease does
not expire.
0-30 0
rap-dhcp-pool-
end
Configures a DHCP pool for remote APs. This is the last IP
address of the DHCP pool.
192.168.11.254
rap-dhcp-pool-
netmask
Configures a DHCP pool for remote APs. This is the netmask
used for the DHCP pool.
255.255.255.0
rap-dhcp-pool-
start
Configures a DHCP pool for remote APs. This is the first IP
address of the DHCP pool.
192.168.11.2
rap-dhcp-server-id IP address used as the DHCP server identifier. 192.168.11.1
rap-dhcp-server-
vlan
VLAN ID of the remote AP DHCP server used if the
controller is unavailable. This VLAN enables the DHCP
server on the AP (also known as the remote AP DHCP
server VLAN). If you enter the native VLAN ID, the DHCP
server is unavailable.
——
rap-local-network-
access
Enable or disable local network access across VLANs in a
Remote-AP.
— disabled
request-retry-
interval
Interval, in seconds, between the first and second retries of
AP-generated requests. If the configured interval is less
than 30 seconds, the interval for subsequent retries is
increased up to 30 seconds.
1-65535 10 seconds
rf-band For APs that support both a and b/g RF bands, RF band in
which the AP should operate:
z g = 2.4 GHz
z a = 5 GHz
a/g g
rfprotect-bkup-
server
IP address of the backup Dell RFprotect server. The AP or
AP group to which this profile applies operates as an
RFprotect sensor.
——
rfprotect-ser
ver-ip
IP address of the Dell RFprotect server. The AP or AP group
to which this profile applies operates as an RFprotect
sensor.
——
rtls-server Enables the AP to send RFID tag information to an RTLS
server.
——
ip-addr IP address of the server to which location reports are sent. — —
port Port number on the server to which location reports are
sent.
——
key Shared secret key. — —
station-message-
frequency
Indicates how often packets are sent to the server. 5-3600 30 seconds
session-acl Session ACL configured with the ip access-list session
command.
NOTE: This parameter requires the PEFNG license.
——
syscontact SNMP system contact information. — —
telnet Enable or disable telnet to the AP. — disabled
Parameter Description Range Default