Reference Guide

1122 | show wms counters Dell PowerConnect ArubaOS 6.0 Command Line Interface | Reference Guide
show wms counters
show wms counters [debug|event]
Description
Show WMS event and debug counters. If you omit the optional debug and events parameters, the show wms
counters command will display wms debug and events counters in a single table.
Syntax
Usage Guidelines
This command displays counters for database entries, messages and data structures. The counters displayed will
vary for each controller; if the controller does not have an entry for a particular counter type, it will not appear in
the output of this command
Example
This example shows part of the output of the command show wms counters.
Command History
This command was introduced in ArubaOS 3.0
Command Information
Parameter Description
debug Show show debug counters only
events Show events counters only. If you omit the debug and events parameters, the show wms
counters will display debug and events counters in a single table.
Platforms Licensing Command Mode
All platforms Base operating system Config mode on master controllers
(host) #show wms counters
Counters
--------
Name Value
---- -----
DB Reads 288268
DB Writes 350870
Probe Table DB Reads 2477
Probe Table DB Writes 952
AP Table DB Reads 143992
AP Table DB Writes 138867
STA Table DB Reads 40404
STA Table DB Writes 99687
Probe STA Table DB Reads 101352
Probe STA Table DB Writes 117566
Probe Register 2476
Probe State Update 37077
Set RAP Type 42552
Set RAP Type Conf Level 152
...