Reference Guide

1005 | show rf optimization-profile Dell PowerConnect ArubaOS 6.0 Command Line Interface | Reference Guide
The output of this command includes the following parameters:
Command History
This command was available in ArubaOS 3.0.
Command Information
Parameter Description
Station Handoff Assist If enabled, this parameter allows the controller to force a client off an AP when the RSSI drops
below a defined minimum threshold.
Detect Association Failure Shows if the profile enables or disables STA association failure detection.
Coverage Hole Detection Shows if the profile enables or disables coverage hole detection.
Hole Good RSSI Threshold Time, in seconds, after a coverage hole is detected until a coverage hole event notification is
generated.
This parameter requires the RF Protect license.
Hole Good Station Ageout Stations with signal strength above this value are considered to have good coverage.
This parameter requires the RF Protect license.
Hole Detection Interval Time, in seconds, after which a station with good coverage is aged out.
This parameter requires the RF Protect license.
Hole Idle Station Ageout Time, in seconds, after which a station in a poor coverage area is aged out.
This parameter requires the RF Protect license.
Hole Poor RSSI Threshold Stations with signal strength below this value will trigger detection of a coverage hole.
This parameter requires the RF Protect license.
Detect interference Enables or disables interference detection.
Interference Threshold Percentage increase in the frame retry rate (FRR) or frame receive error rate (FRER) before
interference monitoring begins on a given channel.
Interference Threshold
Exceed Time
Time, in seconds, the FRR or FRER exceeds the threshold before interference is reported.
Interference Baseline Time Time, in seconds, the air monitor should learn the state of the link between the AP and client to
create frame retry rate (FRR) and frame receive error rate (FRER) baselines.
RSSI Falloff Wait Time Time, in seconds, to wait with decreasing RSSI before a deauthorization message is sent to the
client. The maximum value is 8 seconds.
Low RSSI Threshold Minimum RSSI above which deauthorization messages should never be sent.
RSSI Check Frequency Interval, in seconds, to sample RSSI.
Version Modification
ArubaOS 3.0 Base operating system
ArubaOS 3.4 Output parameters displaying load balancing status were removed. You can now view the
status of the load balancing feature via the commands
show rf dot11a-radio-profile and
show rf dot11g-radio-profile.
Platforms Licensing Command Mode
All platforms Base operating system Enable and Config mode on local and master
controllers