Release Notes

925 | show ap config Dell Networking W-Series ArubaOS 6.4.x| Reference Guide
Parameter Description
Backoff Time
After an AP changes
channel or power settings,
it waits for this backoff time
interval before it asks for a
new channel/power setting.
Error Rate Threshold
The minimum percentage
of PHY errors and MAC
errors in the channel that
will trigger a channel
change.
Error Rate Wait Time
Minimum time in seconds
the error rate on the AP has
to exceed its defined error
rate threshold before it
triggers a channel change.
Noise Threshold
Maximum level of noise in a
channel that triggers a
channel change.
Noise Wait Time
Minimum time in seconds
the noise level has to
exceed the Noise Threshold
before it triggers a channel
change on the AP.
Minimum Scan Time
Minimum number of times
a channel must be scanned
before it is considered for
assignment. Best practices
are to configure a
Minimum Scan Time
between 1-20 scans.
Load aware Scan Threshold
The Load Aware Scan
Threshold is the traffic
throughput level an AP
must reach before it stops
scanning. Load aware ARM
preserves network
resources during periods of
high traffic by temporarily
halting ARM scanning if the
load for the AP gets too
high.