Release Notes

425 | interface vlan Dell Networking W-Series ArubaOS 6.4.x| Reference Guide
Parameter Description Range Default
ip
Configures IPv4 for this
interface.
address
Configures the IP address
for this interface, which
can be one of the
following:
<ipaddr> <netmask>
l dhcp-client: use DHCP
to obtain the IP
address
l internal: IP address
allocated from the
Remote Node Profile.
l pppoe: use PPPoE to
obtain the IP address
— —
helper-address
IP address of the DHCP
server for relaying DHCP
requests for this interface.
If the DHCP server is on
the same subnetwork as
this VLAN interface, you
do not need to configure
this parameter.
— —
igmp
Enables IGMP and/or
IGMP snooping on this
interface.
— —
local-proxy-arp
Enables local proxy ARP. — —
nat inside
Enables source network
address translation (NAT)
for all traffic routed from
this VLAN.
CAUTION: All ports on the
controller are assigned to
VLAN 1 by default. Do not
enable the nat inside
option for VLAN 1, as this
will prevent IPsec
connectivity between the
controller and its IPsec
peers.
— —
ospf
Define an OSPF area. See
ip ospf on page 468 for
complete details on this
command.
— —
pppoe-max-segment-site
Configures the TCP
maximum segment size in
bytes.
128 —
pppoe-password
Configures the PAP
password on the PPPoE
Access Concentrator for
the switch.
1–80 —