Release Notes

Parameter Description Range Default
arp
If enabled, all broadcast ARP
requests are converted to
unicast and sent directly to
the client. You can check the
status of this option using the
show ap active and the
show datapath tunnel
command. If enabled, the
output will display the letter a
in the flags column.
Do not enable this option for
virtual APs configured in
bridge forwarding mode.
This configuration parameter
is only intended for use for
virual APs in tunnel mode. In
tunnel mode, all packets
travel to the controller, so
the controller is able to
convert ARP requests
directed to the broadcast
address into unicast. When a
virtual AP is configured to
use bridge forwarding mode,
most data traffic stays local
to the AP, and the controller
is not able to convert that
broadcast traffic.
— disabled
clone
Name of an existing traffic
management profile from
which parameter values are
copied.
— —
deny-inter-user-traffic
Select this checkbox to deny
traffic between the clients
using this virtual AP profile.
The firewall comand
includes an option to deny all
inter-user traffic, regardless
of the Virtual AP profile used
by those clients.
If the global setting to deny
inter-user traffic is enabled,
all inter-user traffic between
clients will be denied,
regardless of the settings
configured in the virtual AP
profiles. If the setting to deny
inter-user traffic is disabled
globally but enabled on an
individual virtual ap, only the
traffic between un-trusted
users and the clients on that
particular virtual AP will be
blocked.
— disabled
Dell Networking W-Series ArubaOS 6.4.x | Reference Guide wlan virtual-ap | 2088