Release Notes

2057 | wlan hotspot hs2-profile Dell Networking W-Series ArubaOS 6.4.x| Reference Guide
Parameter Description
configured using the wlan hotspot anqp-roam-cons-profile
command.
roam-cons-oi-2
Roaming consortium OI assigned to one of the service provider’s top
three roaming partners. This additional OI will only be sent to a client
if the addtl-roam-cons-ois parameter is set to 2 or higher.
NOTE: The service provider’s own roaming consortium OI is
configured using the wlan hotspot anqp-roam-cons-profile
command.
roam-cons-oi-3
Roaming consortium OI assigned to one of the service provider’s top
three roaming partners. This additional OI will only be sent to a client
if the addtl-roam-cons-ois parameter is set to 3.
NOTE: The service provider’s own roaming consortium OI is
configured using the wlan hotspot anqp-roam-cons-profile
command.
time-advt-cap
no-std-ext-timesrc
timestamp-offset-utc
reserved
This parameter specifies the AP’s source of external time, and the
current condition of its timing estimator.
l no-std-ext-time-src: The AP using this profile has no standardized
external time source.
l timestamp-offset-utc: The AP has a timestamp offset based on
UTC.
l reserved: This setting is reserved for future use, and should not be
used.
time-error
The standard deviation of error in time value estimate, in
milliseconds. The default value is 0 milliseconds, and the supported
range is 0- 2,147,483,647 milliseconds.
time-zone
The time zone in which the AP is operating, in the format
<std><offset>[dst[offset][,start[/time],end[/time]]
Where the <std> string specifies the abbreviation of the time zone,
<dst> is the abbreviation of the timezone in daylight savings time, and
the <offset> string specifies the time value you must add to the local
time to arrive at UTC.
NOTE: For complete details on configuring the timezone format, refer
to section 8.3 of IEEE Std 1003.1, 2004 Edition.
venue-group <venue-group>
Specify one of the following venue groups to be advertised in the IEs
from APs associated with this hotspot profile. The default setting is
unspecified.
l assembly
l business
l educational
l factory-or-industrial
l institutional
l mercantile
l outdoor
l reserved
l residential
l storage
l unspecified
l Utility-Misc
l Vehicular
NOTE: This parameter only defines the venue group advertised in the
IEs from hotspot APs. To define the venue group to be included in
ANQP responses, use anqp-venue-name-profile <profile-name>.