Release Notes

195 | ap system-profile Dell Networking W-Series ArubaOS 6.4.x| Reference Guide
Parameter Description Range Default
lms-hold-down-
period
Time, in seconds, that the primary LMS
must be available before an AP returns
to that LMS after failover.
1-3600 600 seconds
lms-ip
In multi-controller networks, this
parameter specifies the IP address of
the local management switch (LMS)—
the Dellcontroller—which is
responsible for terminating user traffic
from the APs, and processing and
forwarding the traffic to the wired
network. This can be the IP address of
the local or master controller.
When using redundant controllers as
the LMS, set this parameter to be the
VRRP IP address to ensure that APs
always have an active IP address with
which to terminate sessions.
NOTE: If the LMS-IP is blank, the
access point will remain on the
controller that it finds using methods
like DNS or DHCP. If an IP address is
configured for the LMS IP parameter,
the AP will be immediately redirected
to the controller at that address.
— —
lms-ipv6
In multi-controller ipv6 networks,
specifies the IPv6 address of the local
management switch (LMS)—the
controller—which is responsible for
terminating user traffic from the APs,
and processing and forwarding the
traffic to the wired network. This can
be the IP address of the local or
master controller.
When using redundant controllers as
the LMS, set this parameter to be the
VRRP IP address to ensure that APs
always have an active IP address with
which to terminate sessions.
— —
lms-ping-interval
Specifies the interval at which applic-
ation level ping needs to be sent to
primary controller to check the reach-
ability. Applicable only for RAP.
NOTE: If this parameter is changed,
UDP session timeout on an
intermediate router which performs
NATing should be set accordingly. The
preferred timeout value is (lms-ping-
interval + 30sec).
10-60
seconds
20 seconds
lms-preemption
Automatically reverts to the primary
LMS IP address when it becomes
available.
— disabled
maintenance-
mode
Enable or disable AP maintenance
mode.
disabled