Release Notes

1859 | show wlan hotspot h2qp-wan-metrics-
profile
Dell Networking W-Series ArubaOS 6.4.x| Reference Guide
Parameter Description
H2QP WAN metrics
link status
Indicates the status of the WAN Link by displaying one of the following values.
The default link status is reserved, which indicates that the link status is
unknown or unspecified.
l link_down
l link_test
l link_up
l reserved
H2QP WAN metrics
symmetric WAN link
This parameter indicates if the WAN Link has same speed in both the uplink
and downlink directions.
H2QP WAN metrics link
at capacity
This parameter indicates if the WAN Link has reached its maximum capacity.
If this parameter is enabled, no additional mobile devices will be permitted to
associate to the hotspot AP.
WAN Metrics uplink
speed
This parameter indicates the current WAN backhaul uplink speed in Kbps. If
no value is set, this parameter will show a default value of 0 to indicate that
the uplink speed is unknown or unspecified.
WAN Metrics down
link speed
This parameter indicates the current WAN backhaul downlink speed in Kbps.
If no value is set, this parameter will show a default value of 0 to indicate that
the downlink speed is unknown or unspecified.
WAN Metrics uplink
load
The percentage of the WAN uplink that is currently utilized. If no value is set,
this parameter will show a default value of 0 to indicate that the downlink
speed is unknown or unspecified.
WAN Metrics downlink
load
The percentage of the WAN downlink that is currently utilized. If no value is
set, this parameter will show a default value of 0 to indicate that the downlink
speed is unknown or unspecified.
WAN Metrics load
measurement duration
Duration over which the downlink load is measured, in tenths of a second.
Command History
This command was introduced in ArubaOS 6.4
Command Information
Platforms Licensing Command Mode
All platforms Base operating system Config mode on master controllers