Release Notes

173 | ap provisioning-profile Dell Networking W-Series ArubaOS 6.4.x| Reference Guide
Parameter Description Default Range
RSSI is within required range, and if so, connects to
that network. If the RSSI for the modem’s selected
network is not within the required range, the RAP will
then check the RSSI limit of an alternate network (for
example, 3G), and reconnect to that alternate network.
The RAP will repeat the above steps each time it tries
to connect using a 4G multimode modem in this mode.
The RAP determines the RSSI value for the available
network type (for example 4G), checks whether the
RSSI is within required range, and if so, connects to
that network..
If the RSSI for the modem’s selected network is not
within the required range, the RAP will then check the
RSSI limit of an alternate network (for example, 3G),
and reconnect to that alternate network.
The RAP will repeat the above steps each time it tries
to connect using a 4G multimode modem in this mode.
clone <source>
Clone an existing ap provisioning profile — —
link-priority-cellular
<link-priority-cellular>
Set the priority of the cellular uplink. By default, the
cellular uplink is a lower priority than the wired uplink;
making the wired link the primary link and the cellular link
the secondary or backup link.
Configuring the cellular link with a higher priority than
your wired link priority will set your cellular link as the
primary controller link.
0-255 0
link-priority-ethernet
<link-priority-ethernet>
Set the priority of the wired uplink. Each uplink type has an
associated priority; wired ports having the highest priority
by default.
0-255 0
master
Change the FQDN or IP address for the master controller. — —
set <masterstr>
Specify the or IP address or FQDN for the master
controller.
— —
clear
Clear the definition for the master controller in this profile. — —
no
Negates any configured parameter. — —
pppoe-passwd
Point-to-Point Protocol over Ethernet (PPPoE) password for
the AP.
— —
pppoe-service-
name
PPPoE service name for the AP. — —
pppoe-user
PPPoE username for the AP. — —
remote-ap
Specifies that the profile is to be associated with a remote
AP using certificates.
— —
reprovision
Provisions one or more APs with the values in the
provisioning profile.
— —
reset-bootinfo
Restores factory default provisioning parameters to the
specified AP.
NOTE: This parameter can only be used on the master
controller.
— —